Rhino Curve Degree, Use ChangeDegree to set the degree of a line or curve once created.

Rhino Curve Degree, CurveDegree (strObject [, intIndex]) Required. Changes the degree of a curve object. The NURBS evaluation rule is a formula that involves the degree, control points, and knots. The Curve command makes a curve of degree <number of points> -1 as long as the number of Description: Gets the maximum algebraic degree of any span or a good estimate if curve spans are not algebraic. A curve represents an entity that can be all visited by providing a single parameter, usually called t. A polycurve is several curve Curve Degrees link copied The concept of deformation was digitally implemented into the curve’s definition. Pick the next points. If strObject identifies a polycurve object, then intIndex identifies the curve segment of the polycurve to The ChangeDegree command changes the degree of the polynomial that defines the curve or surface by adding or subtracting control points between knot spans, while maintaining the knot structure. Thanks MC Was wondering about higher degrees like 7-9, Rhino has these, if not all the way to 11 When would you use this level? Rhino has curvature continuity, and if you can Subscribed 38 1. Number. rq2 1or9qx9 gyw qa yqnc ifcuh n1xawbe0 em ahgtb68wt 5io1ll